Pointnix Point 800 HD 3D Plus
CBCT capability & upgrade report
Specifications
| Pan / Ceph | Integrated 2D + 3D |
|---|---|
| Released | 2015 |
| In service | 11 years |
| Status | Current |
| Export path | Standard DICOM |
| Market position | Compact CT/pano unit |
Where the Pointnix Point 800 HD 3D Plus stands today
- At 11 years (2015) it's aging but not obsolete. This is exactly the window resellers target for a trade-up you may not need yet.
What it already does that most practices don't use
- The same unit does panoramic/ceph as well as 3D — one capture surface you may be sending out for.
- Output/networking: standard DICOM export. That export path is what lets a scan leave the machine and become something a patient can actually look at.
Upgrade paths for the Pointnix Point 800 HD 3D Plus
- UpgradeCT & Pano configuration (800S HD Plus is a Pano & Ceph variant) in Pointnix's Point 800 family.
- NetworkThe fastest upgrade is almost never new hardware — it's getting the volume off the machine and into a workflow. That alone changes what the box is worth to you.
- ReconfigureSwitching your default to the right FOV/scan mode for implant cases is free, and most practices never do it.
Repair vs. replace: what it costs
Repair: the dominant wear item on any dental CBCT is the X-ray tube — a replacement runs roughly $15,000-$40,000, typically every 3–7 years depending on scan volume. Budget a service contract at about $5,000–$15,000/year and software licensing around $2,000/year. A flat-panel detector is the big unknown — it isn't publicly priced, so get a manufacturer quote before assuming the worst.
Replace: replacement pricing varies by configuration and condition. Before any trade-up, the honest test is whether a networking or software path gets you most of the capability for a fraction of a new unit.
Figures are 2025–26 industry ranges for dental CBCT, not a quote for your exact unit or contract. Sources: Medical Imaging Specialists, DentalTI buyer's guide, The Dental Signal.
Pointnix Point 800 HD 3D Plus — common questions
- Can Alvea use scans from the Pointnix Point 800 HD 3D Plus?
- Yes. The Pointnix Point 800 HD 3D Plus exports a standard DICOM volume, and Alvea converts that volume into a chairside 3D model of the patient's jaw — no new hardware and no new scan. It runs off the cone-beam you already take.
- How much does it cost to repair a Pointnix Point 800 HD 3D Plus?
- The dominant repair on any dental CBCT is the X-ray tube, which runs roughly $15,000-$40,000 and is typically replaced every 3–7 years by scan volume. Annual service contracts run about $5,000–$15,000, and a flat-panel detector is quoted by the manufacturer rather than listed publicly. These are 2025–26 industry ranges, not a quote for a specific unit.
See what a Pointnix Point 800 HD 3D Plus scan becomes.
Run the free, independent report on your exact unit — then turn one of your own scans into a 3D model the patient can see before they decide. No new hardware, no new scan.
Check my Pointnix unit → Try it on one of my scans — first one's free